MIL-L-80061B
3.2.3 Controls. All operating controls shall be located convenient to
the operator at his normal work station.
3.2.4 Safety and health requirements. Covers, quads, or other safety
devices shall be provided for all parts of the machine that present safety
hazards. The safety devices shall not interfere with operation of the
machine. The safety devices shall prevent unintentional contact with the
guarded part, and shall be removable to facilitate inspection, maintenance
and repair of the parts. All machine parts, components, mechanisms and
assemblies furnished on the machine, whether or not specifically required
herein, shall comply with all of the requirements of OSHA 2206 that are
applicable to the machine itself. In addition, the machine shall comply
with all requirements of ANSI B11.6 that are designated therein as the
responsibility of the machine manufacturer. In the event of conflict
between the requirements of the OSHA and ANSI Standards, the requirements
of OSHA shall apply. Additional safety and health requirements shall be as
specified (see 6.2.1 and 6.4).
3.2.5 Lubrication. Means shall be provided to insure adequate lubrica-
tion for all roving parts. Each recirculating system shall include a filter
which is cleanable or replaceable. Each lubricant reservoir shall have means
for determining fluid level. All oil holes, grease fittings, and filler
caps shall be accessible.
3.2.6 Interchangeability. To provide for replacement of worn parts, all
parts shall be manufactured to definite dimensions and tolerances.
3.3 Construction. The machine shall be constructed of parts which are
new, without defects, and free of repairs. The structure shall be capable
of withstanding all forces encountered during operation of the machine to
its maximum rating and capacity without permanent distortion.
3.3.1 Castings and forgings. All castings and forgings shall be free of
scale and mismatching. No process such as welding, peening, or filling with
solder or paste shall be used for reclaiming any defective parts.
3.3.2 Welding, brazing, or soldering. Welding, brazing, or soldering
shall be employed only where specified in the original design. None of
these operations shall be employed as a repair measure for any defective
part.
3.3.3 Fastening devices. All screws, pins, bolts and other fasteners shall
be installed in a manner that prevents change of tightness. Those subject to
removal or ad justment shall not be swaged, peened, staked or otherwise
permanently installed.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business