MIL-L-23400E
inspections are deemed necessary to assure supplies and services conform to
prescribed requirements.
4.1.1 Responsibility for compliance.
All items must meet all requirements
The inspections set forth in this specification shall
of sections 3 and 5,
become a part of the contractor's overall inspection system or quality program.
The absence of any inspection requirements in the specification shall not
relieve the contractor of the responsibility of assuring that all products or
supplies submitted to the Government for acceptance comply with all require-
Sampling in quality conformance does not authorize
ments of the contract.
submission of known defective material, either indicated or actual, nor does it
comment the Government to acceptance of defective material.
4.2
Classification of inspections.
The inspection requirements specified
herein are classified as follows:
First article inspection (see 4.4).
a.
b.
Quality conformance inspection (see 4.5).
4.3
Inspection conditions.
Unless otherwise specified herein, all
inspections, tests, and examinations shall be performed in the manufac-
turer's designated indoor test area under normal operating conditions.
4.4
First article inspection.
When a first article inspection is
required, it shall be applied to the first article submitted in accordance
with 3.1.
Unless otherwise specified (see 6.2,1), first article inspection
Failure of
shall consist of the examination in 4.6 and all tests in 4.7.
the item to pass the first article. examination and all tests shall be cause
.
for rejection.
4.5
Quality conformance inspection.
Quality conformance inspection shall
be applied to each item prior to being offered for acceptance under the con-
Unless otherwise specified (see 6,2.1), quality conformance inspec-
tract.
tion shall consist of the examination in 4.6, the test in 4.7.1 through
4.7.2.3, and the inspection in 4.8.
When a protective finish (paragraph
3.3.5.1) is required, (see 6.2.1 j) the test described in 4.7.4 shall be
performed.
When electromagnetic interference control (paragraph 4.7.3) is
required (see 6.2.1.k) the test described in 4.7.3 shall be performed.
Failure of the item to pass the examination, the test, or inspection shall
be cause for rejection.
4.6
Examination.
The lathe shall be visually examined to determine com-
pliance with all requirements of this specification.
4.7 Tests.
Operational test.
4.7.1
Each lathe shall be operated at no load for not
Proper operation of all controls, motors, adjusting
less than 60 minutes.
mechanisms , and accessories shall be verified during the trial period.
15
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business